Replacement of single strand chains and incorporating three (3) 6" wide full
contact wire mesh belts, has eliminated past problems of full pallet transfers.
Broken boards, missing bottom boards, protruding nails are no longer a transfer
problem. The raising and lowering is done by a heavy duty scissors lift with positive stops for correct height
adjustment. A photo eye detects a pallet in position and sends a signal to either
raise or lower the wire mesh conveying surface for transfer at right angles to the
infeed. The 2.5" heavy duty rollers are driven by a roll to roll drive chain.
This transfer is effective for loads up to 3,500 lbs. depending on pallet construction. These systems are complete with all wiring
and sensing devices. Complete control packages are available. Every system is
fully tested at our manufacturing facility in Denver, Colorado before shipment.
Conveying Industries, Inc.
4995 Lima St. Denver, CO 80239
Phone: 303-373-2035Fax: 373-5149
email: bcarr@conveyind.com
website: www.conveyind.com
|
|
